Simple applications of neon glow lamps
The main voltage monitor
The simplest application is the main voltage monitor that is simply a
lamp that glows when the main voltage is present.
To obtain such a monitor it's enough to connect a resistor in series with the bulb
and connect at a main outlet. The resistance of that resistor may vary on the
type of bulb and the main voltage but it's not critical: about 150 KOhm for
220..230 Vac and about 39 KOhm for 110..120 Vac.
It's very important to choose a resistor that can support the desired voltage or
connect two or more usual resistors in series. The power of that resistor is quite
low and a 0.25 W is usually enough.
The telephone ring monitor
To lit a neon glow lamp a relatively high voltage is necessary (about 80 V) and
this make the realization of a telephone ring monitor quite easy: the voltage of the
telephone line is usually less than 50 V that cannot lit the lamp. Only when
the phone rings there is an AC voltage of about 150 Vac that can lit the bulb.
The low current consummation of glow lamps is very useful in this case since it
doesn't overload the telephone line.
The circuit is very simple and can be mounted into a big telephone plug.
Remark: In certain countries the connection to a telephone line of non
certified devices (such as this one) is not allowed. This application is only
presenter for didactic proposes.
This project may require some modifications to adapt it to each telephone standard,
and may not work in some countries.
Earth checker
With only a neon glow lamp and two resistors it's possible to build a useful tool
that checks if the earth wire of an AC outlet is correctly connected.
In facts the neutral wire and the earth wire are usually connected together in the
transformer and this connection short circuits the lamp that cannot glow.
If the earth wire is not connected or if the live and neutral wires are inverted
the full voltage would be present on the terminals of the lamp that would glow
indicating the presence of a problem.
This circuit is very simple and can be mounted into an AC plug as shown in the
pictures.
This circuit can be adapted to 110 Vac mains by reducing the two resistors to
about 33 KOhm.
Remark: This circuit is very simple and cannot detect every false connection;
for example if the neutral wire is not connected the lamp can't glow even if there
is a problem with the earth wire.
AC outlet tester
To improve the above circuit two more neon lamps are needed as well as some zener
diodes. The circuit is a little bit more complex.
Usually the neutral and the earth are at the same electrical potential and the two
resistors of 150 KOhm are in parallel making all three lamps glow. If a
connection is missing or is inverted the resistors will form a voltage divider that
reduces the voltage and makes one or more lamps dark. The two anti-series zener
diodes are there to avoid that the lamps glows with about the half of the main
voltage.
Lowering the resistance of the resistors and the voltage of the zener diodes this
circuit can be adapted to 110 Vac.
This circuit is a little to complex to fit in a plug but it can easily fit in a
small plastic box.
The meaning of the three laps follows:
| lamp 1
| lamp 2
| lamp 3
| Meaning
|
| on | on | on | Ok
|
| on | on | off | No Earth
|
| on | off | off | Live Neutral inverted
|
| off | on | on | No Neutral
|
| off | off | on | Live Earth inverted
|
| off | off | off | No Live
|
| Questa pagina è anche disponibile in italiano.
|
